dhcpcd -n eth0 for later versions) to enable the device to pull a DHCP address.Īt this point, the device should be able to create or apply an image as normal.Tuxera NTFS 2016 Final + Serial Key Rating: 9,3/10 5324 votes You will also see a line, similar to the following, that shows the command to activate the driver:Īfter the driver is activated, run the following command to verify that it is now active:Īt the bas prompt, enter cd /sbin/ to change directories.Įnter. If the network card driver needs to be activated, you will see a line similar to the following: This command returns information on the network card. Open the zip file and burn the bootcd.iso to a disc.Īt the imaging menu, select Manual mode to display a bash prompt.Īt the bash prompt, type the following command: In the list of ZENworks versions that are displayed, click your ZENworks system version to display the patches available for that version.Ĭlick the latest ZENworks Imaging Driver Update, then download the zip file for your ZENworks version. In the Select a Product list, select ZENworks Configuration Management. Is the image you are trying to deploy 32-bit or 64-bit? The image architecture must match the WinPE architecture used to deploy it.ĭoes WinPE have the correct drivers for the device? For information about adding drivers to a WinPE image, see the article at. If you are trying to deploy a 64-bit image, is the device 64-bit compatible? Click Help > Third Party Imaging Settings. Help is located in the upper-right corner of ZENworks Control Center. Refer to the ZENworks Control Center Help for more information about uploading the correct WinPE. To ensure that both 32-bit and 64-bit devices can be imaged, upload both the 32-bit and 64-bit WinPE distributions.

It requires a 64-bit WinPE from the WADK to boot a 64-bit device.

Third-Party Imaging requires a 32-bit WinPE from the WAIK/WADK to boot a 32-bit device. Before you can upload WinPE, the Microsoft Windows Automated Installation Kit (WAIK) or Microsoft Windows Assessment and Deployment Kit (WADK) must be installed on the machine where you are accessing ZENworks Control Center.

Tuxera 2020